Rock
Aggregate
Cement
Concrete
Soil
Steel
Bitumen/Asphalt
Security Survey Equipment
General Items
AZA 0786 CEMENT SAMPLER
IS 7535 1986, ASTM C 183, AASHTO T 127
Specification:
This is a brass tube approximately 53cm long and 2.8cm I.D. with a wooden handle. Total length approximately 73cm. The tube has the sharp angular edge which conveniently pierces cement bags. An air hole of approximately 3mm dia. is drilled on the tube near handle. Total sample collected at one time is 300cm approximately.
Category: Cement
Related products
AZA 0791 FLOW TABLE
IS:6932 (PART VIII), ASTM C 230, BS 4551:1
Flow Table is used for determining the work-ability of building limes.
Specification:
The flow table consists of a 30 cm dia polish steel plate with 3 engraved annular circles 7, 11 and 19cm dia. The table top is arranged for a free fall of 12.5mm by a cam action. Supplied complete with one brass conical mould, 65mm i.d. at base and 40mm i.d. at top, height of the mould 90mm.
AZA 0794 FLOW TABLE (MOTORISED)
AZA 0800 LABORATORY CEMENT AUTOCLAVE
IS 4031-1968, IS 1624-1960 & ASTM C 151, C 141
Specification:
The autoclave is suitable for conducting accelerated soundness tests on cements or the autoclave expansion test requiring constant steam pressure with the correspondent constant pressure. It consists of a stainless-steel cylinder with a welded heat insulated metal housing attractively finished. The attached control unit encloses a sensitive pressure regulator and pressure gauge. Power switches and pilot lights for controlling the electric heating units. Inside chamber dimensions 10.5 cm diameter x 40.5cm height suitable for operation on 230 V, 50 Hz Single Phase A. C. supply. Supplied complete with test bar holder, special rack to hold specimens above water level in the autoclave and in a vertical position to expose them in the same manner. A Digital PID Controller is fitted for controlling the desired temperature.
Note: Ordinary laboratory cement autoclave with mild steel chambers are also available.
AZA 0803 TENSILE STRENGTH TESTER (ELECTRICALLY OPERATED)
Bs12
The instrument employs a friction free, accurate, double lever system, the load being applied by means of sliding weight on the top lever. The capacity of the units is 900 kgs. After fixing
the briquette in the jaws, the machine is switched on. The sliding weight slides over the calibrated lever thus applying tension to the specimen. A micro switch fitted instantly stop the machine on failure of the briquette and on failure the tensile load is accurately 0.5kg. By means of a marker provided on the sliding weight to its zero position. Suitable for operation on 230 V, 50 cycles, Single Phase, A.C. supply. Supplied complete with one brass briquette mould and one base plate.
AZA 0804 BRIQUETTE MOULD (SINGLE)
IS 269 1958, BS12
Specification:
For casting of cement briquettes for tensile strength tests. It is a two part split mould made of gun metal. Two thumb screws facilitate easy and quick assembling and dismantling of the mould. The minimum cross section of the briquettes cast is 25.4 mm x 25.4 mm. Supplied complete with a steel base plate.
AZA 0805 BRIQUETTE MOULD (THREE GANG)
AZA 0812 GAUGING TROWEL
