AZA 0797 SHRINKAGE BAR MOULD

This is a brass tube approximately 53cm long and 2.8cm I.D. with a wooden handle. Total length approximately 73cm. The tube has the sharp angular edge which conveniently pierces cement bags. An air hole of approximately 3mm dia. is drilled on the tube near handle. Total sample collected at one time is 300cm approximately.

IS 1199-1959, ASTM C-124, AASHTO-T-120.
It is used for determining the flow of cement concrete. Specification:
Consists of a steel table top 76.2cm (30 inch. Dia) Finely machined. The integral cast ribs are designed for support and strength. The
stand is fabricated out of cast iron and is of study
construction. Holes for mounting in foundations are drilled
in the base plate. The ground and hardened steel cam is
designed to fit and drop the table by 12.5mm. Electrically
operated to raise and drop the table top, approx. 15 times in 15 seconds, Suitable for operation on 230 Volts, 50 cycles, A.C. supply. Supplied with one conical mould with two handles, 12cm height, having 17cm. Inside Dia. at the Top and 25cm inner dia. at the base. Complete with a tamping rod 16mm dia x 600mm long one end rounded.

IS269,712,5514,1727,2645,6932(PART IX)BS6463
It is used for the determination of soundness by expansion method of
ordinary and rapid hardening Portland cement , low heat Portland cement
and class 'A' Limes. Specification: It consists of a small split cylinder forming a mould. On either side of the split cylinder. Two parallel indicating arms with pointed ends are attached. Supplied complete with two glass plates and a lead weight.

IS 269 1958, BS12

Specification:

For casting of cement briquettes for tensile strength tests. It is a two part split mould made of gun metal. Two thumb screws facilitate easy and quick assembling and dismantling of the mould. The minimum cross section of the briquettes cast is 25.4 mm x 25.4 mm. Supplied complete with a steel base plate.