AZA 0804 BRIQUETTE MOULD (SINGLE)

IS 4031, 5516, 1727 & 4828, ASTM C-204, BS 4359-2

Specification: Designed to find out specific gravities of semi liquids like mud and other liquids having densities in the range 0.8 to 2.5. It has a stainless steel bam calibrated specific gravities from 0.8 to 2.5. A stainless-steel cup with lid and overflow vent is fitted on one side of the beam. A counter weight with cursor slides over the graduated scale. The beam has a knife-edge at center which rests in a fulcrum fitted in the stand. Leveling screws and spirit level are fitted to the stand.

Spares & Accessories (On Extra Cost):

Punch to cut filter paper discs. Non-perforated disc. Suction bulb, Mercury.

IS:6932 (PART VIII), ASTM C 230, BS 4551:1
Flow Table is used for determining the work-ability of building limes. Specification:
The flow table consists of a 30 cm dia polish steel plate with 3 engraved annular circles 7, 11 and 19cm dia. The table top is arranged for a free fall of 12.5mm by a cam action. Supplied complete with one brass conical mould, 65mm i.d. at base and 40mm i.d. at top, height of the mould 90mm.

IS 4031-1968, IS 1624-1960 & ASTM C 151, C 141 Specification: The autoclave is suitable for conducting accelerated soundness tests on cements or the autoclave expansion test requiring constant steam pressure with the correspondent constant pressure. It consists of a stainless-steel cylinder with a welded heat insulated metal housing attractively finished. The attached control unit encloses a sensitive pressure regulator and pressure gauge. Power switches and pilot lights for controlling the electric heating units. Inside chamber dimensions 10.5 cm diameter x 40.5cm height suitable for operation on 230 V, 50 Hz Single Phase A. C. supply. Supplied complete with test bar holder, special rack to hold specimens above water level in the autoclave and in a vertical position to expose them in the same manner. A Digital PID Controller is fitted for controlling the desired temperature. Note: Ordinary laboratory cement autoclave with mild steel chambers are also available.

IS 4031, 1727 & BS 3892 It is used for mixing cement pastes, mortars and pozzolana.

Specification: The apparatus consists of an epicyclical type stainless steel paddle imparting both planetary and revolving motion, by means of gears. It has two speeds of 140 + 5 R.P.M. and 285 +10 R.P.M. With planetary motions of approximately 62 R.P.M, +5 R.P.M. and 125 R.P.M. +/- 10 R.P.M. Respectively. The stand of the mixer has arrangement to raise or lower the bowl. Complete with stainless steel bowl of about six liters capacity. Suitable for operation on 230 V, 50 cycles, Single Phase A.C, Supply.