Rock
Aggregate
Cement
Concrete
Soil
Steel
Bitumen/Asphalt
Security Survey Equipment
General Items
AZA 0808 PRISM MOULD THREE GANG
IS1727 1967,IS4031 1968,ASTMC394,C64
Specification:
It is supplied complete with base. All parts are marked with the identification number for correct assembly. Each mould is individually verified in the dimensional tolerances, hardness, squareness, flatness & roughness. Size:40.1X40X160mm
Related products
AZA 0787 BLAINE’S AIR PERMEABILITY APPARATUS
IS 4031, 5516, 1727 & 4828, ASTM C-204, BS 4359-2
Specification: Designed to find out specific gravities of semi liquids like mud and other liquids having densities in the range 0.8 to 2.5. It has a stainless steel bam calibrated specific gravities from 0.8 to 2.5. A stainless-steel cup with lid and overflow vent is fitted on one side of the beam. A counter weight with cursor slides over the graduated scale. The beam has a knife-edge at center which rests in a fulcrum fitted in the stand. Leveling screws and spirit level are fitted to the stand.
Spares & Accessories (On Extra Cost):
Punch to cut filter paper discs. Non-perforated disc. Suction bulb, Mercury.
AZA 0789 RING MOULD
AZA 0791 FLOW TABLE
AZA 0795 LE CHATELIER MOULD
AZA 0799 VOLUME CHANGE APPARATUS
AZA 0800 LABORATORY CEMENT AUTOCLAVE
AZA 0811 VIBRATING MACHINE
IS4031 1968, IS1344 1959, BS 4550. Concrete moulds are easily cast by using a tamping bar or a vibrating table. However air trapped in cement mortar paste cannot be thus removed while casting cement mortar moulds. Easy method is to impart greater vibrating of lesser amplitude to the mould while casting This is achieved in a vibrating machine. Vibrating machine is used for the preparing of mortar cubes for the determination of compression strength of ordinary and rapid hardened Portland cement, low heat Portland cement, Portland blast furnace cement and high alumina cements.
Specification:
The machine consists of a vibrating frame assembly and an electric motor mounted on a sturdy base. The complete frame assembly consists of a vice to hold a 70.6 mm cube mould and two studs threaded at top and a hopper to feed the sample in the mould. This assembly is supported on four springs and has an in built rotating shaft which rotates eccentrically and thus imparts vibrations to the entire frame. A balance weight is an integral bottom part of the frame. The center of gravity of the assembly is brought to the centre of the eccentric shaft within a distance of 25 mm below it. The electric motor drives the shaft of the frame and thus imparts required vibration to the moulds.
The frequency of vibration is 12000 +/- 400 Vibration Per Minute. Supplied complete with on 70.6 mm Cube Mould with loose base plate, a time switch 0-5mins x 1mm.
Spares: Set of springs, belt and belt guard. Optional: Digital Preset Timer can be supplied at an extra cost.
AZA 0813 PLUNGER PENETRATION APPARATUS
EN 413-2, 459-2, 1015-4 The plunger penetration apparatus is used to determine the consistency of fresh mortar, building lime and masonry cement. The test apparatus consists of a base to place the test cup and a vertical column holding the penetration plunger assembly. The drop default height is adjusted to 100mm.Theplungerassemblyweight is90g. The plunger penetration apparatus is supplied complete with: ! TestCup,Ø80mmX70mm ! Tamper
