AZA 0818 BENTONITE SLURRY SAMPLER 50 METERS

This is a brass tube approximately 53cm long and 2.8cm I.D. with a wooden handle. Total length approximately 73cm. The tube has the sharp angular edge which conveniently pierces cement bags. An air hole of approximately 3mm dia. is drilled on the tube near handle. Total sample collected at one time is 300cm approximately.

IS 1199-1959, ASTM C-124, AASHTO-T-120.
It is used for determining the flow of cement concrete. Specification:
Consists of a steel table top 76.2cm (30 inch. Dia) Finely machined. The integral cast ribs are designed for support and strength. The
stand is fabricated out of cast iron and is of study
construction. Holes for mounting in foundations are drilled
in the base plate. The ground and hardened steel cam is
designed to fit and drop the table by 12.5mm. Electrically
operated to raise and drop the table top, approx. 15 times in 15 seconds, Suitable for operation on 230 Volts, 50 cycles, A.C. supply. Supplied with one conical mould with two handles, 12cm height, having 17cm. Inside Dia. at the Top and 25cm inner dia. at the base. Complete with a tamping rod 16mm dia x 600mm long one end rounded.

IS 1199-1959, IS 4031 1968 BS 1881, ASTM C 151, C490. It is used to measure the dying shrinkage of concrete autoclave expansion of Portland cement and potential expansive reactivity of cement aggregate combinations in mortar bars during storage, on self drying. Specification: The instrument consists of a channeled or a round base over which two vertical pillars are fixed. An adjustable cross plate is at the top. A dial gauge, reading to .002mm x 5mm. Can be located upon a 6.5mm. dia ball or other reference point cementedinthespecimen.Onthebasethereis similarrecessed seating in which can be placed a second ball or reference point in the specimen.
Complete with a stainless steel standardization bar with insulated grip and with 6.5mm dia. Balls mounted in the ends. The unit can be supplied with an Electronic Dial Gauge at extra cost if indicated at the time of placing the order.

IS 4031, 1727 & BS 3892 It is used for mixing cement pastes, mortars and pozzolana.

Specification: The apparatus consists of an epicyclical type stainless steel paddle imparting both planetary and revolving motion, by means of gears. It has two speeds of 140 + 5 R.P.M. and 285 +10 R.P.M. With planetary motions of approximately 62 R.P.M, +5 R.P.M. and 125 R.P.M. +/- 10 R.P.M. Respectively. The stand of the mixer has arrangement to raise or lower the bowl. Complete with stainless steel bowl of about six liters capacity. Suitable for operation on 230 V, 50 cycles, Single Phase A.C, Supply.